Semi-trailer tire inflation considerations?
Do not inflate the semi-trailer. Do not inflate when you have just driven. Wait until the tires are completely cooled before inflating. Because the tires of vehicles that have been driving for a long time have a higher temperature, we know the principle of thermal expansion and contraction. If the tire temperature is too high, the air pressure is high. Certainly affected, so in order to correctly judge the air pressure, we need to wait for the tire temperature to cool before inflating.
Semi-trailer tire inflation precautions. Semi-trailer is a large-scale transportation vehicle that is commonly used nowadays. It has high work efficiency and fast transportation speed. It is very important for the semi-trailer tire inflation. The semi-trailer custom manufacturers below will talk about tire inflation precautions.
1. Do not inflate the semi-trailer. Do not inflate when you have just driven. Wait until the tires are completely cooled before inflating. Because the tires of vehicles that have been driving for a long time have higher temperature, we know the principle of thermal expansion and contraction, and the temperature of the tires is too high. It has a certain influence, so in order to correctly judge the air pressure, we need to wait for the tire temperature to cool before inflating.
2. Before the tire is inflated, we need to check whether the inflation is clean. If the inflatable equipment or the surrounding environment is not clean, it is easy to get moisture, oil, impurities, etc. into the tire, resulting in deformation or deterioration of the inner tube rubber. There is also the attention to the cleaning of the valve. The tire is in contact with the ground for a long time. There are often dirt and dust on the valve. Before the inflation, we need to clean the valve to prevent impurities from entering the tire and damaging the tire.
3. When inflating, try not to loosen or take out the valve core, and forcibly inflate by increasing the air pressure to prevent the valve screw from tripping and leaking. After the inflation is completed, apply water to the valve to check for air leaks, so as to tighten or replace the valve core as appropriate. When filling the gas, it should also be equipped with a tight valve cap to prevent the sediment from entering the valve.
