How to standardize the use of high beam lights for semi-trailers
Driving at night, the biggest headache for everyone is to encounter the driver who drives the high beam to the end. This kind of behavior when the car does not switch lights is not uncommon during the night driving. The glare of the high beam will not only shake the eyes, but also Seriously affecting the line of sight, in fact, driving in the city at night, in most cases, the road has good lighting, there is no need to open the high beam. In the road section where the road lighting is not very ideal, the high beam light is an important factor in inducing a car accident.
How to standardize the use of high beam lights in semi-trailers. In the driving process of semi-trailers, the high beam lights cannot be used at will, so as not to affect the safety of the vehicles on the opposite side. So how do semi-trailers regulate the use of high beam lights? The following is a small series of semi-trailers for you to introduce in detail.
1. When there is no central isolation facility or a road with no centerline, the high beam can not be used within 150 meters from the opposite direction.
2. Semi-trailers cannot use high beam lights when there are no central isolation facilities or narrow bridges, narrow roads and non-motor vehicles with no centerline.
3. When there is no streetlight, poor lighting or foggy, rain, snow, sand and other low visibility, the high beam can not be used when driving in the same direction and driving in the same direction.
4, when overtaking at night, the light should be used alternately to remind the vehicle in front.
5. The semi-trailer cannot use the high beam when cornering through an intersection controlled by traffic signals.
If the semi-trailer is difficult to start, first check if there is any problem with the engine, whether the fuel pressure and cylinder pressure are within the normal range; whether the injectors can work normally in order; check the valve timing, ignition timing and sparking of the spark plug. , [semi-trailer reversing] did not find any problems. Through a series of inspections, the engine has oil and fire, that is, the cold car can't start. At this time, you should consider whether it is a problem with the water temperature sensor.
